TN330 & TN360 Toner Reset Instruction

When your Brother printer has run out of toner, it will stop printing at once. Before refilling it, you should reset it firstly. So that you can extend the working life of the cartridge effectively, and make a full use of it. Or the LCD will keep displaying message like “Toner Life End” or “Replace Toner” if you refill the toner directly. Next, I will show you how to reset TN330&TN360 Toner settings on Brother printers:

Brother-TN330-Original-Black-Toner-Cartridge

Brother-TN360BK-Original-Black-Toner-Cartridge

For DCP Printer Series:

1. Open the front cover.
2. Press the Clear/Back button on the control panel. The display will read “Replace Drum 1. YES 2. NO” (DISREGARD THIS MESSAGE) Proceed to step
3. Press the start button, press the up or down arrow key until “00” appears on the LCD display and then press OK.
4. Close the front cover and the operation has now been completed.

For MFC Printer Series:

1. Open the front cover.
2. Press the Clear/Back button on the control panel.
3. Press in order *,0,0.
4.  Close the front cover and the operation has now been completed.

For HL Printer Series:

1. Open the front cover.
2. Turn on the power switch while holding down the “GO” (Blue LED) button until all LEDs on the control panel light up. (approx. 5 seconds)
3. Release the “GO” button and check that all LEDs are off.
4. Press the “GO” button twice, pause then press the “GO” button six times for TN-330 (Standard Yield) Toner, or seven times for TN-360 (High Yield) Toner.
5. Close the front cover and the operation has now been completed.

If you need toner refills, come to 123ink.ca, we ensure you will get the best high quality printing supplies with the lowest costs possible from ordering your ink and toners online from  our website.